Flash Harlo OS on a Bitaxe Gamma 601 (Free, ~2 Minutes)
Replace stock AxeOS with Harlo OS via browser flash: uncapped OC, fleet dashboard, custom display — settings preserved via OTA.
1. Confirm support + back up pool config
Check your model is listed (Gamma 601, Naja Duo, Hammer, NerdQaxe++, Nexus + 13 more) at harlolabs.com.
In AxeOS, screenshot/note your pool URL, port, wallet/worker, timezone. OTA preserves settings; factory flash wipes them — backup either way.
2. Flash from the browser
Open harlolabs.com in Chrome/Edge → pick your exact model.
Plug USB data cable to miner. If not detected: hold BOOT, tap RESET, release BOOT, reconnect.
Choose OTA image (keeps settings) or factory (clean slate). Click install and keep USB connected until done.
harlolabs.com → select model → Connect USB → OTA update → wait for success → power on3. First boot + verify
Power on — self-test runs automatically, then mining resumes.
Open the Harlo dashboard: confirm live hashrate, wall power, both temps charting.
Already on HashWatcher? It keeps working after the flash.
4. Tune overclock safely
Stock values are one click away — note them before touching anything.
Raise frequency in small steps (+25-50 MHz), watch temps + rejected shares for 15 min per step.
Voltage last, minimally. Gamma 601 sips ~15-20W stock — budget PSU + cooling headroom before pushing.
| Symptom | Fix |
|---|---|
| Climbing rejects | Back frequency down one step |
| Thermal throttle | Improve airflow / lower voltage |
| Unstable after flash | Factory re-flash, re-enter pool config |
5. Design your display
Put the readings you care about (hashrate, power, temp, pool) on the miner screen with your own artwork behind them.
Screenshot it and post in Discord #show-off — community feedback catches bad OC fast.
Tools used in this playbook
- Harlo OS (Bitaxe Firmware) — ★★★★½ 4.5/5
- Bitaxe Gamma 601 (Hardware) — ★★★★☆ 4.0/5